[Top] [All Lists]

[Towertalk] Re: CATV Hardline Splices

To: <>
Subject: [Towertalk] Re: CATV Hardline Splices
From: (Jim White)
Date: Tue, 4 Jun 2002 12:33:49 -0400
this is how W3AU has his long CATV hardline runs here in FL

he has a piece of aluminum tubing which he has split both ends on and he
slides it over one side to start....the ID of the tubing is very close to
the OD of the hardline....

then he solders a short length small diameter copper/brass (hobby/plumbing?)
tube over the center conductor...

after soldering the small tubing to both sides of the center conductor
splice he packs pieces of the dielectric around it and then slides the
aluminum tube over the splice....

hose clamps tighten the split tube and voila....I am sure it is a small
impedance bump due to the diameters changing slightly but at HF hopefully
this is acceptable!  (JI?)


----- Original Message -----
From: <>
To: <>; <>
Sent: Monday, June 03, 2002 5:40 AM
Subject: [Towertalk] Re: CATV Hardline Splices

> Most of my Barrel Connector adapters failed after a few years
> for various reasons.
> One of my longest lasting splices was made by cutting down the
> hardline, exposing ~1/2 inch of center conductor from each side,
> slipping a short piece of 1/4 inch copper tubing over the center
> conductors, soldering, filling in gap with insulation and using a
> sleeve of aluminum tubing with hacksawed splits in the ends,
> 1/8 inch larger than the hardline jacket, taped ends, hose clamped
> over each side of the splice.  Be sure to put the outside splice over
> one side BEFORE soldering the center conductors together :-) !
> Tom  N4KG
> ________________________________________________________________
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> _______________________________________________
> Towertalk mailing list

<Prev in Thread] Current Thread [Next in Thread>