Hey Guys - It's not true. Any of the below comments forwarded (">" and
">>") with this message.
There is so much wrong with the below forwarded comments (">" and ">>")
that I do not have the time to type it all in here. Here's a short
1. Engineer your station to *keep the lightning out*.
2. High floor hamshack locations need to have their SPG lightning
protection at a ground level entry-point. From there, run your coax/control
3. Check out the appropriate design/photos/discussion on my website
4. Read the PolyPhaser book(s)
5. Read other lightning protection books.
With a properly designed and implemented grounding system, lightning will
*ignore* your premises as the storm progresses through your neighborhood and
*around* your properly grounded tower/feedlines/SPG, QTH, etc.
It happens all the time in my location, as it does in many hams locations
(the storm splitting and going around properly grounded towers and QTHs).
That's how you protect from a direct hit - you don't allow any build-up of
static and hence, no arc-over (lightning).
I don't have time now for reply comments - I'm headed out of town for the
Doubters, do a bit more research on the subject. How do commercial radio
stations stay on the air 24/7 with all of their equipment connected.
BTW, as I have said before here, I keep my IC-781, IC-4KL, 4 Packet radios,
6 rotor control boxes, 2 ham PCs, phone lines, modems, and 5 other PCs in my
house connected at all times. Never had a hit that affected me (direct or
otherwise) - except once when I removed the equipment grounds on my rotor
control boxes briefly and had to replace a diode in each after a storm.
Think about it.
----- Original Message -----
From: "Ford Peterson" <email@example.com>
Sent: Sunday, July 28, 2002 5:46 PM
Subject: Re: [Towertalk] grounding system
> Glenn writes:
> > Any ground length over five feet from equipment to ground rod is almost
> > useless for protection from a close lightning strike. It is fine for a
> > electrical safety ground, but too much voltage will be imposed on the
> > equipment for the equipment to survive fro a close strike.
> > Hope that this helps.
> > 73
> > Glenn
> > WB4UIV
> Watching and learning from this thread, I'm beginning to think I should be
> operating from a metal dog house with a ring of ground rods directly at
> station equipment (sarcastic). I've got about 6' of ground buss running
> behind the operating position. Total distance to the rod is about 6'-7'.
> fail to see how it can get any better than this, short of the metal dog
> house approach.
> I think what all respondants to this thread are saying is that if you get
> close strike, you are TOAST! Trying to engineer for a direct hit is
> impossible with the light gauge metals and structures that are quite
> when compared to a bridge or a sky-scraper.
> How about some practical advice for the 90% of hams that cannot possibly
> engineer a perfect solution. A second floor shack is TOAST. What should
> this guy do to protect his family and possessions? Forget the radio! I'd
> expect a sensitive piece of equipment to fry in the presence of a million
> volts at a million amps. I would rather have that insured equipment
> completely melt down and fry while shunting most of the strike to ground
> rather than burn 100% of my worldly possessions.
> Self Supporting Towers, Wireless Weather Stations, see web site:
> Call 888-333-9041 to place your order, mention you saw this ad and take an
additional 5 percent off
> any weather station price.
> Towertalk mailing list