> I recently acquired a Rohn 25G Tower and I have a
> few questions for the list members.
> Why are the holes on the section legs 2 different
> sizes? One is 3/16' and the other is 1/4".
It's possible they are different so that it would be
obvious which holes should line up... IOW, to make it
difficult for the installer to *accidentally* align
the bottom hole of the upper section with the top hole
on the lower section and thus not have the two
sections mated completely. It could also be to
optimize the amount of bolt vs the amount of tower leg
left intact. As has been said, the truth may never be
> Can I drill out the 3/16" holes and make them 1/4"
> like the rest or should I leave well enough alone?
In a word, NO! That would destroy the integrity of
the zinc plating (galvanizing). Buy the honest-to-
goodness Rohn JBK kits for Rohn 25. A couple $ per
> Last but not least, where can I buy Rohn accessories
> for a 25G? Guy wire brackets, etc.
Companies geared for the Amateur market:
Geared for the Industrial market (a little slow; be
sure to ask about stock first):
As always, check the HUGE links database on
PeoplePC: It's for people. And it's just smart.