I have always wrapped my coax around the mast rather than have a drop loop.
Never had any snagging or problems with the coax. I tape all the coax
together and treat it as one cable. I make a few turns around the mast with
the coax. This way it neither gets too tight turning one direction, nor too
loose turning the other direction.
[mailto:firstname.lastname@example.org]On Behalf Of Ken Hopper
Sent: Monday, August 12, 2002 10:47
Subject: [Towertalk] [Q] o.k. to wrap coax around mast to prevent snagging?
Dear Tower and Rotor gurus,
I have had bad luck trying to make a loop of coax + steppir control cable
will not snag on the top of my roof top tower. The quad-pod has a square top
piece where the mast goes through a sleeve bearing. The coax + ctrl cable
seems to snag there. I am using RG213 that is pretty loose and flexible in
this heat (95F) and it won't keep a stiff loop out clear from the tower. I
tried a two foot right angle home brew bracket off the mast and it was
in half this weekend when I made a mad dash to the East (hihi).
Can you wind the coax + Ctrl cable around the mast like a telephone cord so
that it unwinds when the rotor is turned the opposite direction?
does the coax couple to the mast/tower in some undesireable way?
I have seen those commercial TV trucks with microwave dishes and the cable
coiled around the mast. Wonder if it is a whole different deal?
your knowledgeable suggestions please,
de ken (newbie tower owner) n9vv
n9vv at arrl dot net
Self Supporting Towers, Wireless Weather Stations, see web site:
Call 888-333-9041 to place your order, mention you saw this ad and take an
additional 5 percent off
any weather station price.
Towertalk mailing list