I am a rotor challenged new owner...:) Just got my new
Prosistel rotor with the "C" controller. I've never had a rotor before
so forgive my dumb questions.
I've wired everything up as required, etc. in preparation to
installing this rotor on my new tower. What I am confused about
are several items.
1. What should the display read when the rotor is in the North stop
position? I think it should read "000" to indicate it is stopped at the
north position. Correct??
2. I want to set the rotor at it's north stop so I can mount and drill
the mast to install the anti-spin bolt that's recommended prior to
the final mounting of the rotor. Is my above assumption about
positioning conducive to my doing this??
3. Is the mounting position of the rotor itself a critical issue insofar
as the north stop postion is concerned? I'm mounting the rotor and
the mast on the ground prior to raising the tower. Is this going to
present me with a problem?
4. Do any owners of the Prositel rotor have any other advice and/or
suggestions for me??
I would be most appreciative of any and all feed back. This my
first tower, rotor, beam, etc. so I am trying to do everything "right"
the first time...:) Of course Murphy is bound to show up so I'm
trying to be prepared for that....:) You can contact me via my e-mail
if you want too as well.