I have witnessed two crane installations of R45 tower.
Sub sections were previously assembled equal to the
spacing between guy wires (30 and 40 ft respectively).
For perfectly vertical lift, THREE straps were attached,
one to each leg, going down through the center. This
worked VERY well. The other assembly used a single
heavy strap and the crane operator / tower guy had to
play with positioning to get each sub-assembly vertical
for engagement. I prefer the three strap method.
I assume the same technique could be used for disassembly.
On Fri, 13 Sep 2002 18:46:47 -0700 "Earl" <email@example.com> writes:
> Seeking a little advice about the removal of a well guyed AB 105 to
> 135 ft.
> A 75 ft crane is easily available and wondered if, when the guys are
> free, a couple of inches lift at the crane top level would allow
> removal of the lowest section (previously unbolted) to clear the
> base and then lay over the assembled tower for unbolting.
> The tower and guys w/grips and insulators will be offered for sale.
> Location is Hansville WA which is on the W side of the Puget Sound.
> Any better ideas appreciated as we have no expeience in this area
> Earl W7TK
> --- StripMime Report -- processed MIME parts ---
> text/plain (text body -- kept)
> Self Supporting Towers, Wireless Weather Stations, see web site:
> Call 888-333-9041 to place your order, mention you saw this ad and
> take an additional 5 percent off
> any weather station price.
> Towertalk mailing list
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit: