On my 130 ft high 80M dipole, I use a short center insulator.
To connect the ladderline, I cut out one of the center blocks,
leaving the insulation on the wire, run the wires through the
holes in the insulator, then strip the ends and wrap them
around the antenna wire where it is wrapped back on itself
and solder (silver solder is best). The line comes straight
down where and is tied to a tree stump a few few above
ground with nylon cord. I've had only one break in several years.
Another idea I've seen uses a flat rectangular insulator
(I forgot the specific material) with 4 holes, one at each
end for the antenna wire, and two on the bottom for the
ladderline. Each hole has a small thimble to relieve the
stress in the wire. The wires were clamped back on each
other with some kind of small clamp.
On Wed, 1 Jan 2003 "Barry Kirkwood" <email@example.com> writes:
> Looking for ideas about strain relief for 450 ohm ladder line (the
> plastic ribbon stuff with square holes in it).
> Like: where one connects it to the centre of a dipole, seems uncouth
> to just hang it off the joints it makes with the antenna itself.
> Have punched small holes in the webs and woven stranded fishing line
> through the holes, taken the line back to the insulator above to
> take weight of the feedline.
> Am I doing right?
> Any ideas?
> Happy 2003
> Barry Kirkwood PhD ZL1DD
> Signal Hill Homestay
> 66 Cory Road
> Palm Beach
> Waiheke Island 1240
> NEW ZEALAND
> ph/fax 64-9-372-5161
> --- StripMime Report -- processed MIME parts ---
> text/plain (text body -- kept)
> AN Wireless Self Supporting Towers at discounted prices,
> See http://www.mscomputer.com
> Wireless Weather Stations now $349.95. Call Toll Free,
> 888-333-9041 for additional information.
> Towertalk mailing list
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!