[Top] [All Lists]

[TowerTalk] grounding

To: <>
Subject: [TowerTalk] grounding
From: (S. J. Blackwell)
Date: Wed May 21 02:25:57 2003
The time rate of change of current in a bolt is such that inductance is very 
important as is the location of that inductance.
Best regards,
Sam, W5LU

>From: "Wes Attaway \(N5WA\)" <>
>To: "Pete Smith" <>, <>,   "Kelly Taylor" 
>Subject: RE: [TowerTalk] grounding
To: <>
>Date: Tue, 20 May 2003 21:30:06 -0500
>Pete makes a good point, up to a point.  I do not believe "low
>inductance grounding" is an issue in the single-point grounding
>scheme problem.  Reasonable attention with decent sized wire and
>copper strap will suffice for the purpose of controlling the
>problem of imbalances in potential at different ground points.
>Low-inductance questions are mainly associated with RF grounding,
>which is much different from tieing various gound points
>together.  Going from a second floor room to ground for the
>purpose of a so-called DC ground is not much of a problem.  Your
>coax should be grounded near the ground out at the tower, and
>maybe again just outside the house before coming up to the second
>floor, so I don't think it would much of an issue as far as the
>second floor goes. DC grounding and RF grounding problems are two
>different animals.

Protect your PC - get VirusScan Online

<Prev in Thread] Current Thread [Next in Thread>