There are special instructions for TIC Ring installations in New
England. They should only be mounted at ground level.
Seriously, they ARE a pain in the butt to climb around. I climb with
the 2 lanyards on my belt, and always strap one above the ring before
disengaging the one below the ring. I'd recommend about 3 feet from
the top, to give you enough room to maneuver.
I have one guy bracket about 4 feet below a RIngrotor on my Rohn 45.
I don't think it really matters if you're a few feet further away,
but don't get too close and make clmbing around it more difficult.
If you want to see a pic, go to
Barry, W2UP (Go FRC)
On 11 Jun 2003 at 12:51, Jim Idelson wrote:
> Hi everyone,
> I'd like your advice on how many feet below the flat top section my
> new 1022E ring should be located, and where should I put the top guy
> bracket. The rotor will go on my new Rohn 45G tower. I will be using a
> standard guy bracket and possibly a set of torque arms. My goal is to
> have the rotor as high as possible, but to also be able to climb over
> it. I also want to keep things from becoming too cramped near the top.
> Your suggestions, please?
> Jim Idelson K1IR
> email firstname.lastname@example.org
> web http://www.designet.com/k1ir
> See: http://www.mscomputer.com for "Self Supporting Towers",
> "Wireless Weather Stations", and lot's more. Call Toll Free,
> 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
> TowerTalk mailing list
Barry Kutner, W2UP Internet: email@example.com
Newtown, PA Frankford Radio Club