Just may have to do this. The conduit is a straight run with sweep 45's at the
ends. The only trouble is that there is CATV hardline in there, and that is
hard to remove without doing damage. I may try a stiff fish tape first.
Jim Idelson K1IR
---------- Forwarded Message ----------
FROM: Jim Lux <email@example.com>
TO: Jim Idelson <firstname.lastname@example.org>, TowerTalk Post
DATE: Fri, 01 Aug 2003 09:03:36 -0700
RE: Re: [TowerTalk] Pull rope twisted in conduit
My vote would be to pull all the cables and ropes out, and suck a brand new
rope through, then use that one to pull several new ones. A shopvac on one
end will nicely pull mason's twine or equivalent through quite a long
distance of conduit. If you need more air drag, a wad of masking tape
works, as does one of those foam antenna balls.
(You did limit the sum of bend angles in the conduit to 360 degrees
between pull boxes, right? Some of those NEC rules exist for a good reason)
At 10:51 AM 8/1/2003 -0400, Jim Idelson wrote:
>I pulled a couple of small cables through my 100 foot 3" conduit that goes
>the house to the tower. This time it was extremely difficult. I can't even
> the cable another inch. I'm lucky that it's just sticking out the other
>Seems like the pull rope is twisted around some of the cables; and getting
>worse every time I pull something else through. What's the best way to deal
>A. Start using cable pull lubricant and don't wory about it?
>B. Fish a new pull rope through the conduit? If this is the right answer,
>what's the right way to do it? This sounds like the proper thing to do, if I
>can figure out how.
>Jim Idelson K1IR
>See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
>Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
>any questions and ask for Sherman, W2FLA.
>TowerTalk mailing list