|Subject:||Re: [TowerTalk] P.S.: Surge supression|
|From:||"Rob Atkinson, K5UJ" <email@example.com>|
|Date:||Fri, 07 Nov 2003 23:45:10 +0000|
I'm certainly no expert but I'll take a stab at this.|
<The concept of "RF ground loop" does not compute for me. It seems we are getting audio concepts in here.>
Yes, one of the problems is RF in the audio stages causing distortion.
<The ground length as a function of frequency will be all over the place from band to band.>
Yes again--it's a moving target.
<It seems that the best way to keep RF out of the shack is not have it there in the first place.>
Ideally this would be excellent but usually only broadcasters can do this. Hams don't have the money to put AF stages in one room or building and have a separate (remote) tx site where the RF is. Most hams use transceivers where everything (AF and RF) is in one (small) metal box (cabinet) on a table in front of the op.
<Certainly it would be difficult (impossible?) to simply send it to ground in most shacks. The concept of safety and RF grounds are apples and oranges. Am I missing something here?>
You can get circulating rf currents flowing between pieces of equipment that are connected with coax cable (the unwanted rf flowing on the external surface of the shield) in one direction and returning via the ground bus. I'm not exactly sure how these are instigated but I think a factor is nearness to the tx antenna so some or all may be induced by the field. I had severe problems of this type until I took corrective measures since there was no way for me to get far enough away from my antennas. symptoms are fuzzy tx audio, tingling on transmit on the mic or cabinets. I was simply trying to say that I thought running a wire from a SPD to the shack ground would exacerbate this but thanks to a few responses I think it's a nonissue: if like me, you have already had rf problems and dealt with them this should not reverse anything. If you have not had any, this should not start anything.
you can break up gnd. loops by putting chokes (ferrite beads, common mode filters, a.k.a. 1:1 ununs) in/on your inter-equipment feedlines which help isolate the equipment.
Rob Atkinson K5UJ
Is your computer infected with a virus? Find out with a FREE computer virus scan from McAfee. Take the FreeScan now! http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||RE: [TowerTalk] 40 Meter Vertical Construction, Macie, Gordon|
|Next by Date:||Re: [TowerTalk] Lightning, surge protection, WD0M|
|Previous by Thread:||Re: [TowerTalk] P.S.: Surge supression, S. J. Blackwell|
|Next by Thread:||[TowerTalk] tower on a roof, Bob Jaeger|
|Indexes:||[Date] [Thread] [Top] [All Lists]|