|To:||"Clary, Steve" <Steve_Clary@URMC.Rochester.edu>,email@example.com|
|Subject:||Re: [TowerTalk] Can anyone identify this tower?|
|From:||W0UN -- John Brosnahan <firstname.lastname@example.org>|
|Date:||Tue, 03 Feb 2004 14:36:04 -0600|
You are missing the key shot of a joint between sections to be definitive--but there are some clues and some questions.
1) The welding does not look like Rohn--On a Rohn tower you can take a straight edge across two legs and it will slide up and down without hitting any of the diagonals. On a Universal Tower doing this test will result in hitting the diagonals. In the first picture it is hard to be sure but it appears the diagonals are raised enough to make it look like Universal Tower.
2) A magnet will easily answer the steel vs. aluminum question.
3) The ten 6ft sections could be mis-remembering six 10ft sections and the taper seems to indicate three different sizes-- of 20 ft each. But hard to tell from the photo.
4) Rohn tower is swaged in such a way as to let the water run on the outside of each section joint. Universal is bass-ackwards and each section joint causes the water to run down the inside.
5) Universal has the last brace end up on a diagonal whereas Rohn ends on a horizontal. A photo of a joint would help here as well. The Universal top diagonal is just butt welded on the end of the rod without being bent and welded over a larger surface.
6) Rohn sections have the ends of the bracing bent back towards the center of the section, whereas Universal has the bottom (only) bent the other way--towards the end.
So, a photo of the area where two sections join -- probably 10 ft up (and not 6 ft) -- would answer much more definitively if it is Universal Tower. And Universal makes a tilt-over base. If it is NOT aluminum then all bets are OFF!
But my guess is that it is Universal Tower with two sections of 18 inch, two sections of 14 inch, and two sections of 11 inch. And it would make a very nice 80M vertical or support for some relatively smaller Yagis-- preferably VHF.
At 12:54 PM 2/3/2004, Clary, Steve wrote:
I don't think the current owner really know what it is. He says it's made by "Roan Tower Co" and it's a "pro 60". (Of course Rohn Towers doesn't have a 'pro 60' model that I can find.
--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.564 / Virus Database: 356 - Release Date: 1/19/2004
_______________________________________________ See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA. _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||Re: [TowerTalk] Combining antennas, Jim Lux|
|Next by Date:||Re: [TowerTalk] P-P voltage on an antenna, Bob Nielsen|
|Previous by Thread:||Re: [TowerTalk] Can anyone identify this tower?, Tower (K8RI)|
|Next by Thread:||[TowerTalk] shunt feed, K8NKE|
|Indexes:||[Date] [Thread] [Top] [All Lists]|