|Subject:||[TowerTalk] Texas Tower (Irving, TX) Aluminum Tower info|
|From:||Mahlon Haunschild <firstname.lastname@example.org>|
|Date:||Sun, 09 May 2004 14:43:05 -0500|
Have recently acquired quite a bit of Texas Tower Mfg. (in Irving, TX not Richardson) 10" face aluminum tower. Construction method used for this is:
- Legs: 1" x 1" aluminum angle stock - Braces: Stamped/punched out of 18 ga. aluminum & riveted to legs
Apparently I'm not the only one who's seen this stuff, since there's at least one other posting in the archives referring to this tower product line. What I would like to know, for this tower design, is:
- How were the sections joined? - How were guys attached? - What was used to mount it? Hinge base? J-bolts? What?
This stuff is far too light to use as a real tower (and there's no way I'm going to climb it) but it's gonna make a dandy wire antenna support & maybe even a 1/4 wave vertical if I can ever figure out how to get it together.
Would appreciate any/all info. Thanks.
Mahlon - K4OQ
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||Re: [TowerTalk] 4 Square phase line length question, Tom Rauch|
|Next by Date:||[TowerTalk] Modelling a basic stack, N4CW|
|Previous by Thread:||Re: [TowerTalk] 4 Square phase line length question, Tom Rauch|
|Next by Thread:||[TowerTalk] Outlet for Tower Sections, Jerry|
|Indexes:||[Date] [Thread] [Top] [All Lists]|