[Top] [All Lists]

Re: [TowerTalk] Conversion to W6NL 40M MOXON

To: <>
Subject: Re: [TowerTalk] Conversion to W6NL 40M MOXON
From: W0UN -- John Brosnahan <>
Date: Tue, 25 May 2004 17:09:30 -0500
List-post: <>

After a quick look at the paper and the associated .gif drawing that gave the tubing sizes, I couldn't help wondering about the structural soundness of the intersection between the elements and the loading structures, which involve two different sizes of element tubing and a third size in the cross pieces. Dave literally wrote the book on physical design of yagis, but that looks like a pretty critical area. Didn't I hear somewhere that NT1Y's new 80M F12 yagi failed at similar points in the elements?

Just FYI. NT1Y's failure was not due to any structural issues that are relevant to the Leeson/Moxon design. The F12 Yagi has top guys that are center mounted so low that under some ice conditions the tips can bend down enough to raise the pre-guy section to have the guys end up on the wrong side of the element and actually pull down rather than up. Or so it appears to me after reviewing the photos of the failures.

There are a lot of ways to make a Leeson/Moxon antenna so that
the loading is structurally stronger than the rest of the element.  One
obvious way is to mill a block of aluminum so that one side has
a groove to match the diameter of the element and the other side
has a groove at right angles that matches the diameter of the loading.

Another way is to make a clamshell similar to the Hygain element
to boom mounts.  In any case the results of the modeling are very
promising and it would be a lot of fun to play with the antenna to
see how close a real one is to the model.

--John W0UN
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (
Version: 6.0.675 / Virus Database: 437 - Release Date: 5/2/2004

See:  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

TowerTalk mailing list
<Prev in Thread] Current Thread [Next in Thread>