I've been following this for a while and keep seeing reference to "brazed"
I've never seen a brazed joint in water pipes. Soldered, but never brazed.
The temperature for brazing is much higher than soldering and would be
enough to show some serious oxidation on the copper. Brazing would require
the copper to be at a "cherry red" heat to get the stuff to melt. In most
homes the amount of heat required would cause charring on any wood near the
It may not be permitted, but I'd trust a good brazed joint any day over a
compression fitting that can corrode. I've had compression fittings
completely lose contact with ground rods.
Roger Halstead (K8RI, EN73 & ARRL Life Member)
N833R, World's Oldest Debonair (S# CD-2)
> In a message dated 5/26/04 10:17:54 AM Pacific Daylight Time,
> firstname.lastname@example.org writes:
> > However using
> > brazed water pipes is not recommended. The brazed connections represent
> > seriously weak electrical joint and may fail prematurely under thermal
> > stress of high currents.
> Yessireebob. The only NEC ground connections allowed are compression
> exothermic (i.e. Cadweld).
> Steve K7LXC
> TOWER TECH -
> Professional tower services for commercial and amateur
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
> TowerTalk mailing list
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
TowerTalk mailing list