|To:||Steve <email@example.com>, Towertalk@contesting.com|
|Subject:||Re: [TowerTalk] CDE HAM II Rotor . . . another question|
|From:||Bill Aycock <firstname.lastname@example.org>|
|Date:||Thu, 27 May 2004 22:06:29 -0500|
Steve- the problem may be in calibration, not the resistor. My CDE Ham III
has a simple procedure, and I think the type II is the same. A slightly
shortened version is:|
Turn the unit on and turn the rotator to the most counterclockwise position. Use the screw in the center of the meter to move the needle to line up with the leftmost "S" limit. Push in the "calibrate" knob. Rotate the knob to place the needle on the right hand "S" limit. Push in the "Calibrate" knob.
This procedure can be repeated anytime to check the calibration. With the power off, the needle should aligne with the left "S".
That is what the manual says.
At 08:51 PM 5/27/2004 -0400, you wrote:
Several of you were kind enough to help me a few weeks with a question about a CDE HAM II rotor. Now I have another issue and thought I'd try my luck again.
Bill Aycock - W4BSG
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||Re: [TowerTalk] Raising the Mast w/Antennas, AA6DX|
|Next by Date:||RE: [TowerTalk] Belts/Harness legality, Kirk Harding|
|Previous by Thread:||[TowerTalk] CDE HAM II Rotor . . . another question, Steve|
|Next by Thread:||Re: [TowerTalk] CDE HAM II Rotor . . . another question, wb4mle|
|Indexes:||[Date] [Thread] [Top] [All Lists]|