[Top] [All Lists]

[TowerTalk] Re: Bolts, ID??

To: <>, <>
Subject: [TowerTalk] Re: Bolts, ID??
From: "Robert Shohet" <>
Date: Sun, 15 Aug 2004 23:40:55 -0400
List-post: <>
Hi Mel,

The diameter of the head of both bolts is 9/16".

I can't tell you the thread pitch since I am not familiar with that

I am very skeptical of these bolts sold to me as "Rohn Hardware",
but I wanted to inquire of those more knowledgeable than I.

Tnx & 73

Bob KQ2M

----- Original Message ----- 
From: <>
To: <>; <>
Sent: Sunday, August 15, 2004 11:31 PM
Subject: Bolts, ID??

> You didn't state the diameter nor thread pitch. That could be important.
> The "3-letter" identifier on the top, just being stamped there in ink,
> me think these are common grade from Home Depot. This is how the clerk
> up the value and uses a printed/book bar code to charge you at the check
> stand. I don't think I would use these on a tower leg.
> YMMV, 73
> Mel Frost


See:  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>