[Top] [All Lists]

[TowerTalk] Re: [CQ-Contest] Desk design

Subject: [TowerTalk] Re: [CQ-Contest] Desk design
Date: Tue, 17 Aug 2004 17:53:14 EDT
List-post: <>
I used a couple of "seconds" from a local oak cabinet manufacturer.  They 
were base pieces for  bathroom vanities.  One was a drawer stack, the other had 
two doors on it.  They were a little high so I cut the base off each one to 
drop it about three or four inches.  I then nailed two 3/4 inch plywood pieces 
together (there is a big gap between the two and I wanted no sag) to make a 1 
1/2 inch desk top which I covered with Formica.  After trimming the Formica, I 
then put 1 x 2 oak for trim. Pretty cheap to do and it looks sharp.

It is incredibly strong.  Along with two complete stations and all kinds of 
other stuff stacked in three tiers, I can stand on the top and there is no sag.

If you need plywood, let me know.  I have twelve sheets laying around I 
bought to get ready for Hurricane Charley....:-)

Bill K4XS

See:  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Re: [CQ-Contest] Desk design, Cqtestk4xs <=