For the Molex connector I believe you need a .062" Molex pin extractor, but
the connectors and pins are dirt cheap from Yaesu. You might just want to
put a new connector on the new cable.
I have no idea about the connector at the rotator end. Are the pins even
removable? Again, you might just want to buy a new connector.
73, Bob - W3YY
----- Original Message -----
From: <kelly@thejohnsons.ws>
To: <towertalk@contesting.com>
Sent: Wednesday, November 03, 2004 9:35 PM
Subject: [TowerTalk] Yaesu Rotator connector replacement
I need to replace my Yaesu Rotator Control Cable, which means that I have
to remove the connectors on both ends and put those connectors on
a new cable. Anyone have some helpful hints or tips for removing
the pins from both connectors? I've use pin extraction tools in the
past for similar connectors. Will those tools work with these pins?
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|