Try running the rotor through it's entire rotation back and forth several
times. I have this problem from time to time with a 1022 as far back as
1996 or earlier and this works for me.
73, KB! John K1AE
John Allen - PC Support Solutions www.pcsupportsolutions.com
PC House Calls: Computer HW/SW/Network debugging, installation, maintenance,
mailto:email@example.com 978 779-6189 M: 508 361-6229
From: firstname.lastname@example.org [mailto:email@example.com]On Behalf Of
Sent: Sunday, November 28, 2004 12:25 AM
To: TowerTalk Post; CQ-Contest Post; YCCC
Subject: [YCCC] TIC Ring Potentiometer Failure?
Not far into the contest this weekend, we began to have trouble with the TIC
1022E [a 2003 unit]. It exhibits erratic readout and rotation behavior. The
load is an Optibeam 4-el 40m yagi. I recently tightened the drive motor to
eliminate slippage of the ring gear. I suspect something has happened to the
potentiometer that feeds back rotor position back to the controller. A
of the towertalk archives shows that there have been problems like this in
past [1996/1997]. I went up the tower to have a look this afternoon, but did
not see enything suspicious. There were no bad external wiring connections,
etc. I sprayed the drive shaft and what looks like the position pot shaft
contact cleaner from the outside. That did nothing, but I suspect I would
to disassemble the motor to get the spray into the right places.
Jim Idelson K1IR
email k1ir at designet.com
YCCC Reflector mailto:firstname.lastname@example.org
Yankee Clipper Contest Club http://www.yccc.org
Reflector Info: http://lists.contesting.com/mailman/listinfo/yccc
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
TowerTalk mailing list