|To:||"George Liepins" <email@example.com>,<firstname.lastname@example.org>|
|Subject:||Re: [TowerTalk] Wilson Crankup Info Needed|
|Date:||Wed, 1 Dec 2004 20:22:31 -0600|
George I have a 3 section rotator at the bottom Wilson. I've replaced the cables. I even replaced the first cable without laying the tower over horizontal.
But....if one cable broke, you got to replace them all if it's like mine.
If your tower it the two section, with only one cable going up over the pulley and down inside to the bottom to the second tube section, you can reach inside the bottom and remove the bolt.
Then thread the new cable down inside the section and replace the bolt.
I've done it, totally safe. But it's tough to describe via email.
And remember, you should check over the pulley sheaves.
----- Original Message ----- From: "George Liepins" <email@example.com>
Sent: Wednesday, December 01, 2004 7:59 PM
Subject: [TowerTalk] Wilson Crankup Info Needed
The cable on my TT-45 Wilson Crank-up tower rusted through and broke inside the 4" outer tube. Installation instructions don't cover details like how is the cable attached to the bottom of the inner 3.5" section.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||[TowerTalk] Wilson Crankup Info Needed, George Liepins|
|Next by Date:||[TowerTalk] Re: TIC Ring QRN, David J Rodman MD|
|Previous by Thread:||[TowerTalk] Wilson Crankup Info Needed, George Liepins|
|Next by Thread:||[TowerTalk] Re: TIC Ring QRN, David J Rodman MD|
|Indexes:||[Date] [Thread] [Top] [All Lists]|