Towertalk
[Top] [All Lists]

RE: [TowerTalk] Antenna height

To: <TowerTalk@contesting.com>
Subject: RE: [TowerTalk] Antenna height
From: "Keith Dutson" <kjdutson@earthlink.net>
Reply-to: keith@dutson.net
Date: Thu, 9 Dec 2004 08:41:06 -0600
List-post: <mailto:towertalk@contesting.com>
The higher location will yield a lower take-off angle for improved DX
contacts.  However, short range contacts may suffer a bit.  If you have the
means, add the extra height and another tribander.  You can phase them
together for some really good results.

Keith NM5G

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of John (N1JP)
Sent: Wednesday, December 08, 2004 6:41 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Antenna height

Would anyone know if it would be worth the investment of time and money to
add another 12 ft to my existing tower. It is presently at 48 feet and I was
thinking of bringing it up to 60 feet. I'm basically looking for a
performance upgrade for my small house lot.  I only have a tribander up
there and this would give me a half wave length on 20 meters from the
ground. Wish I had a modeling program. Thanks in advance.


John  (N1JP)

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>