Mike. I think there are a couple of simpler solutions if you use a split
driven element. I matched a 3 el 10m beam as follows:
Two pieces of 75 ohm coax in parallel used as a quarter wave transformer
will give you a good match. Furthermore, these 2 coaxes can be wound around
a cylindrical piece of pvc to make a choke so you get dual use of the
matching section. We used this little beam at 131 ft plus a 4BA at 50 ft in
the 10m contest to win the NW division a couple of years ago.
If you don't want to do this, buy or build a ferrite core xfmr to do the
73, Dan, N5AR
[mailto:firstname.lastname@example.org]On Behalf Of Michael Harris
Sent: Friday, December 10, 2004 2:46 PM
Subject: [TowerTalk] 20M Yagi
I'm currently putting together the material requirements for building a
three element 20M Yagi based upon the optimised design in the ARRL
"Antenna Book" 18th edition.
Falklands is a windy place, not particularly high but persistent and a
real antenna killer due to fatigue. With this in mind I am planning to
use the heavy duty element taper schedule. At present I don't have enough
thick wall 2" tube for the three element boom but I do for a two element
of either reflector/driven element or driven/director element combo. Even
two elements are better than no elements.
The latter should give a little more gain. I would assume that either of
the parasitic element lengths would remain as per the detail in the book
with just the driven element having to be retuned. Driven/director with
the greatest spacing probably least susceptible to change. Interesting
that for the optimised designs of the 18th edition the reflector is much
closer spaced to the driven element than that shown in the 13th edition
Because of this I can only make a stab at the approximate radiation
resistance of the driven element for a two element array at somewhere in
the region of 20 ohms.
Pondering the option of "T" match but not too much information available.
Does one try and match the 20 ohms or so to 50 ohms with the "T" of go for
200 ohms and transform it down with a 4:1 balun, this could make for
rather long arms maybe. In either case I would be interested in some ball
park figures for the mechanicals, also the option to do away with the
series capacitors in the "T" arms by detuning the element on the hf side.
I have a copy of the ARRL "Yagi Antenna Classics" on order but also
thinking about getting a copy of "Physical design of Yagi Antennas" by
Now if I could only get the software of the 20th edition without having to
replace my 18th edition rather earlier than is reasonable.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
TowerTalk mailing list
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
TowerTalk mailing list