|To:||Jim Lux <firstname.lastname@example.org>|
|Subject:||Re: [TowerTalk] Rusty tower|
|From:||Tom Anderson <WW5L@gte.net>|
|Date:||Sun, 19 Dec 2004 12:20:15 -0600|
Jim, et. al:|
One of the companies in our family owned corporation used to be Riverside Industries of Tulsa OK, Provo UT, and Fort Worth TX. They made huge high voltage electrical transmission towers. The Fort Worth plant also had a large 300+ ft. tall "test bed" (yes it was lighted per the FAA) where towers would be assembled and cables attached and then the tower stressed to whatever design limits the customer wanted. The tests would usually stress a design to the point where it ripped apart just to see what it would take, usually far in excess of design specs.
Several times while I was in college and later I was asked to take photos of the plants for in house use and annual reports.
All three plants had several large open tanks where large pieces of steel that were to be assembled into towers were dipped during galvanizing. The galvanizing process is a several step operation. There were a couple near boiling point "pickling baths" of various acids, etc. that dissolved, neutralized, etc. any rust, corrosion, dirt, etc. on the steel. You had to leave these steel sections in the picking and neutralization baths long enough to heat them up. To drop a piece of cold (temperature) steel into the galvanizing zinc solution meant risking the zinc "explode" showering the area with bits of what had been molten zinc. I was never there when this happened, but I saw the results of someone not heating the steel enough by all of the galvanizing splatters on the inside of the building. It could be a real mess. State and local EPA officials were real particular how we disposed of the pickling materials when the plant(s) drained and refilled them with new chemicals. Also the pickling materials could really open up your sinuses if you got too close.
I know actually very little technically about the galvanizing process since I was a newspaper reporter/photographer. I just related what the employees and foremen in the plant told me when I'd visit there, since I also had to occasionally write stories for the company employee newspaper and annual report.
Jim Lux wrote:
Unless you have much, much more time than money, start calling "galvanizing" in the yellow pages. Some galvanizing places only take nice clean stuff, but others will take beat on, rusty stuff and sandblast/wirebrush/hot tank it before galvanizing. It's surprisingly reasonable (unless your time is truly free... the folks they hire to do this unpleasant tedious work are at minimum wage or thereabouts). Most places will also pick up and deliver for a nominal (few tens of $) fee (unless you're hundreds of miles away). Galvanizers charge by the weight of what they are galvanizing (not the price of the zinc, or anything that would make sense...nope.. they just hang the widget from a scale and drop it into the tank...)
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|