|To:||"Richard Zalewski" <firstname.lastname@example.org>, "N6KJ" <email@example.com>|
|Subject:||Re: [TowerTalk] Station Ground|
|From:||"K8RI on Tower Talk" <firstname.lastname@example.org>|
|Date:||Fri, 14 Jan 2005 17:16:00 -0500|
Sounds good to me.|
What I use here: The bare #2 that gets used for the grounding network runs on into the basement and up into the shack. Here it is harnessed across the back side of the desk and has a number of cable clamps fitted to it. From the cable clamps I run 1/2 inch tinned copper braid to each grounding lug. I crimp a ring lug on the end of the braid for each rig, but flatten it out and slip it under the cable clamp on the #2 cable. It's flexible and allows the rigs to move a *little*. I don't put in much excess.
Roger Halstead (K8RI, EN73 & ARRL Life Member) N833R, World's Oldest Debonair (S# CD-2) www.rogerhalstead.com
I will probably get beat up on this but what I have is a 6'x3"x1/4" aluminum bar behind my operating position. It is drilled and tapped every 6". Then at the end I have a 1/4 x 20 bolt that I attached my large ground braid that goes about 5 feet to my ground rod system. Have not had problems with ground loops etc.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|