|To:||Jim Brown <email@example.com>,"Tower Talk List" <firstname.lastname@example.org>|
|Subject:||Re: [TowerTalk] Station Ground|
|From:||Jim Lux <email@example.com>|
|Date:||Fri, 14 Jan 2005 16:44:26 -0800|
At 03:45 PM 1/14/2005, Jim Brown wrote:
On Fri, 14 Jan 2005 15:36:11 -0800, Jim Lux wrote:
The classic example is a mobile rig, with the -12V wire going to the battery, and the rig grounded to the car chassis at some point via the antenna coax. The chassis bonding gets corroded, so now there's a potential difference between parts of the chassis due to, for instance, headlights or starter. The radio becomes a low impedance connection between the two parts of the chassis.
There are also scenarios where the starter motor has an explicit ground wire that comes loose. Likewise, the alternator.
But, for a more direct case, let's say you've got your radio hooked up with some sort of manky fairly small zipcord directly to the battery (or, say, the cigarette lighter aka 12VDC accessory outlet). You've also got the radio chassis grounded to the chassis, and you've done a bangup job bonding the car's chassis, so there's a real low impedance. Most of the 12V return current will flow through the chassis, rather than in the intended wire. Now your power supply is over a huge loop, ripe for EMI/EMC problems.
If you have a fuse in both power leads (as is common practice), then having the chassis ground essentially makes the negative lead fuse useless, too.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|