|Subject:||Re: [TowerTalk] Station Ground|
|Date:||Sat, 15 Jan 2005 21:34:00 -0500|
The shack ground here is a 3/4" dia. X 6' copper pipe. The equipment is connected to the copper pipe using the braid stripped from old coax. The braid end going to the copper pipe is slipped under a hose clamp that goes around the pipe. The other end is flattened and a hole, big enough to fit over the equipment's ground stud, is made. Solder is flooded into the flattened end solidifying it for placement over equipment's ground stud.
By the way, several number 8 wires are run from the 6' copper pipe to the various ground rods.
Hope this helps.
At 05:02 PM 1/14/05, Richard Zalewski wrote:
I will probably get beat up on this but what I have is a 6'x3"x1/4" aluminum bar behind my operating position. It is drilled and tapped every 6". Then at the end I have a 1/4 x 20 bolt that I attached my large ground braid that goes about 5 feet to my ground rod system. Have not had problems with ground loops etc.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
|<Prev in Thread]||Current Thread||[Next in Thread>|