Another way of cutting the non soldered braid is to use a piece of thin
wall Al tubing whose ID is about the same as the OD of the dielectric.
Slip that piece of tubing between the braid and dielectric. Then trim
the dielectric with an utility knife cutting against the Al tubing.
That way the dielectric and center conductor are both protected.
We always cut the braid and
dielectric flush with a single rotary cut using a single edged razor blade,
going through the cable jacket, braid and dielectric in a single cut
operation (5 seconds), stopping when the center conductor is contacted by
the blade, without nicking that conductor.
Doug Renwick VA5DX
PO Box 50, Clavet, Saskatchewan, Canada S0K 0Y0
First VE5 9BDXCC
What profit it a ham if he gains all the awards yet forfeits his soul?
I'll run the race and I will never be the same again.
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
TowerTalk mailing list