Towertalk
[Top] [All Lists]

Re: [TowerTalk] replacing coax on a crank-up

To: Craig Clark <jcclark@worldpath.net>, towertalk@contesting.com
Subject: Re: [TowerTalk] replacing coax on a crank-up
From: Bill Aycock <baycock@direcway.com>
Date: Fri, 01 Jul 2005 17:00:40 -0500
List-post: <mailto:towertalk@contesting.com>
Craig- This was a good contribution- But- I have a question or two about 
the 9913. one- did you use common 9913 or one of the more weather-proof 
varieties- two- if common 9913, how did you treat it to improve the 
end-sealing?
Thanks- Bill-W4BSG

At 02:51 PM 7/1/2005 -0400, Craig Clark wrote:


> >    1. crank ups and coax (George M. Badger, III)
>
>Hello George et al,
>
>For most HF applications, a good RG213 is more than adequate for feeding
>antennas on a crank-up tower. That said, with my Tri-ex W67, I used Davis's
>Buryflex: since I sell it, why not use it.
>
>I cycled my tower ever year to lubricate the top bearing and eye-ball the
>connections to ensure that they were water tight.  The Bury-flex was up for
>years and showed no signs of degradation from water or UV rays and was not
>damaged when the tower crashed, hi hi.
>
>Standard LMR400 is not the best choice as it has a solid center conductor.
>If you want to use LMR, use UF which has a stranded center conductor. The
>loss numbers on LMR400 and Buryflex are about the same. Bflex is a bit more
>expensive due to its burial grade outer layer of plastic.
>
>When you engineer the coax you have to take in to account the length from
>the shack to the base of the tower and then up the tower. I chose to secure
>the coax and rotor cable to the standoffs so you had to calculate the
>length of each loop. I found this to be better than letting the cable have
>free run.
>
>I ran a low loss coax, 9913, from the shack to the antenna switch at the
>base of the tower. I then ran Bflex to each of the antennas. I had on this
>tower:
>
>Cushcraft:
>          X-7
>          5 element 6 meter
>          19 element 2 meter
>          146/440 dual band vertical
>
>I can't imagine using RG214 unless you already have it. Especially if it is
>silver plate. $$$$$
>
>Good luck.
>
>
>73, Craig Clark, K1QX
>
>RADIOWARE AND RADIO BOOKSTORE
>PO  BOX 209
>RINDGE NH 03461
>603 899 6957
>WWW.RADIO-WARE.COM

Bill Aycock - W4BSG
Woodville, Alabama 


_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>