> I have been told, or read somewhere, that the test to destruction failure
> point of screw anchors is that the weld holding the helix to shaft will
> before they pull out or break the shaft.
> 73 Don
This could well be true; in my one (and hopefully only) case of screw anchor
failure, the rod (if I remember right this was a 4+ foot rod, with a 4" or
6" auger on the end? Can't remember exactly) pulled apart approximately in
the middle, not where the helix/auger were welded.
The rod had deteriorated to a fairly thin diameter (new was maybe 3/4" to 1"
(again I don;t remember exactly), but what came out of the ground was as
thin as a pencil.
I think what happened was, with the extra loads of a wind storm (50MPH), the
rod material was so thin, it pulled like taffy. What came out of the ground
literally looked like it had stretched before it snapped.
These were the days before digital cameras, so I don't have photos in
digital format, but I do have hard copy prints somewhere, if anyone on the
list wants to see what can happen to these materials over time. The proud
tower, antennas, feedlines, and MUCH work can be trashed very quickly!
TowerTalk mailing list