On Jan 16, 2006, at 17:12, Kinney Johnr17512",
J.Kinney@freescale.com wrote:
>
> I have a question pertaining to my HyGain HG52SS tower or any other
> tower of this type for that matter. The question: Does anyone have a
> model or has anyone attempted to model the wind loading of this
> type of
> tower, at heights less than full extension? This tower is rated at 9
> square feet at 50 MPH average wind speed. It would be interesting, to
> me at least, to see a graph or table stating the increase in wind load
> capacity as the tower is lowered to its resting height (21 feet.) I
> asked this question via email directly to HyGain, after their
> purchase
> by MFJ, but never received a reply.
> Thanks for the bandwidth.
> 73's
> John Kinney KA7CVJ
Frank Travanty, W9JCC, has written an Excel spreadsheet and an
accompanying article which I have used for my TX472MDP tower. It
does just what your looking for in terms of allowing you to graph
your particular installation.
It takes a bit of data input in terms of your particular tower. You
will need wind loading figures per section, amount of overlap of
sections. psi rating of your mast, antenna windloading figures and
some other data all of which I don't recall since using the sofware.
Anyway, you end up with a nice graph of height versus wind speed
maximum for your installation.
I thought it was very well written and implemented. I have a copy of
the Word document and the Excel spreadsheet. Contact W9JCC to see
about getting them. I'm not sure if it's OK for me to send, but with
his permission, I would be glad to forward a copy of each.
73,
Jim
KJ0M
...
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
