> Many of the towers made today are designed to sway and you dont want to guy
> them such as the popular line of Universal Aluminum towers. The steel
> towers are built to be self supporting to a certain height as described by
> engineering specs. The same with the Aluminum towers and you should pay
> big attention to their specs. The 40 foot Rohn 25G
> wont hold a lot when self supporting. In fact outside of a small beam
> forget it without a set of guys!
> Rohn will tell you the size tower they advise and if its 25 G pay attn to
> the need for guys. If its HDBX dont try to guy it as its designed to sway
> Towers all vary as to max height and that height should depend greatly not
> on what you want but as to the antennas to be put on them and that antenna's
> windload. Antennas should be a certain height above ground depending on
> what bands you intend to work. I personally think that the good DX starts
> 50 feet with the average triband beam. Dont try to impress the
> neighborhood with big towers but build what is necessary and safe. BTW the
> 56 foot
> HDBX Rohn is small in
> windload capacity and safer if you build it to just 48 feet!
> Pay big attention to windload and the specs of the beam and the tower before
> you determine height of your tower. My triband Higain is at 50 feet
> selfsupported aluminum with a 26 inch base.
> I have 5.5 sq feet of concrete
> holding it up.
5.5 square feet? Do you mean CUBIC feet? If so, that is definitely NOT
enough concrete. 5.5 Cubic YARDS makes more sense to me, as my
Universal towers ALL have from 4 to 6 Cubic YARDS of concrete below them.
> And it works great. And yes, it does have some sway as much as 6
> inches as it is is designed.
> Good luck!
> TowerTalk mailing list
TowerTalk mailing list