On Jan 24, 2006, at 12:00 AM, Tom McDermott wrote:
> You mention an L-network, but do you additionally have a
> capacitor in series with the shunt-feeding arm?
> Or is your
> L-network just one series-L from the coaxial feed point to
> the arm, and one shunt-C from the arm to ground?
> If you have just the two parts, (and no series-C feeding the
> Shunt-arm), then you can get some really high voltages.
> On 80 meters, and with a 15-m shunt arm, the input Z to the
> Shunt-feeding-arm will look something like 50+j375. In parallel form,
> that's 2860 ohms resistive in parallel with 382 ohms inductive.
> That high-resistive number should ring alarm bells!
> If the shunt-C of your tuning network cancels out a fair
> amount of that parallel-L (forming an almost parallel resonant
> circuit), then your network can have a really high voltage
> point across the shunt-C but also across the series-L of your
> tuning network. Thus you could have arcs either across the
> shunt-C, or across the series-L. Especially so if there are tap
> points on the inductor that go over to a switch (bringing those
> tap points physically close to one another).
I've considered this possibility, even to the point of possibly
winding a new coil just for 80m.
I'm seeing about 200 pf on 80m on the shunt, and around 600 pf on 160m.
> Using a series-C in the feed arm brings the impedance
> down to a reasonable value, placing high-voltage stress just on that
> one component - the series capacitor.
What value series cap should I be using? What voltage rating should
Bill Coleman, AA4LR, PP-ASEL Mail: firstname.lastname@example.org
Quote: "Not within a thousand years will man ever fly!"
-- Wilbur Wright, 1901
TowerTalk mailing list