I learned it twice that worm-gear drive rotators also loose their gears.
Two of my Prosistel PST2051 failed with a beam of 0,9m² at 10m height and
only 60km/h wind gusts at that time.
The worm axle pushed the bearing completely out of the housing which ruined
the worm wheel immediately.
I was quite happy it happened during the warranty period and it was repaired
without any problem by the factory, but I still do not believe that those
rotators are good for 2,5m² of windload as claimed, so I use them for real
small antennas only since then
firstname.lastname@example.org] On Behalf Of CubexCo@aol.com
In a message dated 2/28/2006 12:02:54 PM Eastern Standard Time,
and clamp and that held it. Only problem came when we had a really bad
windstorm, instead of slipping, it took the gears out in the rotor.
This sounds like a typical Hy-Gain rotator failure. Is that right?
With the current worm-gear drive rotators (e.g. Orion, BigBoy, AlfaSpid),
won't suffer the same fate.
TowerTalk mailing list