I purchased the TB-3 because the Yaesu GM-050 bearing didn't mount on to the
Rohn AS25G plate. It wasn't even close! Believe it or not I think I might be
overkilling the entire project. This is a 60ft tower, bracketed to my house
at 20'. I will be guying it. I used 52 bags of 60lbs concrete at 4ft deep
X 28" X 28".
The bracket is installed through the siding with carriage bolts and secured
inside a room with a pressurized 2 X 6 board. The bracket is bolted into a
footing and the other three carriage bolts for the bracket go between 3
studs inside the room. I don't think it is going anywhere once it is guyed.
The tower has the 9ft top section with the peak. Will be using an aluminum
mast 1 1/4" OD with Yaesu G-450A rotor. Beam is a Mosely TA-33M and stacked
Any recommendations would be great but the concrete is already poured and
bracket is installed. Am waiting for better weather to start stacking tower
>From: Jon Zaimes AA1K <email@example.com>
>Subject: re: [TowerTalk] TB3 Thrust Bearing
>Date: Wed, 15 Mar 2006 11:15:40 -0500
>If the original bolts are not long enough to tighten down on a 1 1/4 inch
>mast, you could replace them with longer bolts that would do so.
>But the TB-3 is a bit of overkill for that small a mast. A 2 x 4 block of
>treated wood drilled slightly larger than the mast would be sufficient. In
>fact Rohn used to sell such a block of wood (I think it was oak or cedar
>rather than treated) with a hole for a 2-inch mast.
TowerTalk mailing list