[Top] [All Lists]

Re: [TowerTalk] AS25G plate

Subject: Re: [TowerTalk] AS25G plate
From: "Bruce Ferratt" <>
Date: Wed, 15 Mar 2006 16:06:23 -0500
List-post: <>
If one wants to use a thrust bearing on a Rohn 25G and have a rotor plate 
too, the accessory shelf will only fit at the very top of the 'top 
section',... this is where there is no zig-zag/crossbar in the Rohn 
tower,... or down at the very next section (9-10ft down)  One needs to use 
two (2) shelves for this configuration.  The only way an AS25G plate will 
fit about 4-5ft down in the top section is if you: 1) cut a crossbar 
out,...OUCH! and there goes the integrity of the top section ( I guess you 
could re-weld this back) or, 2) cut the plate down and notch it for the 
rotor install.
I think that using a mast that goes down further inside (10ft to the next 
section) is overkill for my application.  I am mounting a Tribander with a 
stacked vertical for 2m/440.
Thanks for your recommendations!

>Subject: Re: [TowerTalk] AS25G plate
>Date: Wed, 15 Mar 2006 11:32:46 EST
>Why do you need to cut it?
>The Yaesu rotors should fit without redrilling.  I mounted one  yesterday.
>Skip,  KJ6Y
>_Communications Service  Co_ (


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>