[Top] [All Lists]

Re: [TowerTalk] Phasing verticals and stubs

To: Ian White GM3SEK <>
Subject: Re: [TowerTalk] Phasing verticals and stubs
From: Don Havlicek <>
Date: Wed, 05 Apr 2006 11:36:56 -0400
List-post: <>
Comments inserted below:

Ian White GM3SEK wrote:
> Don Havlicek wrote:
>>The 'right triangle' system utilizes two verticals per selected 
>>direction with the third 'floating'. The 'equilateral triangle' system 
>>uses all three verticals simultaneously,
> Any triangle system can be used with either two or three elements 
> energized - check with ON4UN's book for details. In either case, the 
> most practical and versatile system for beam switching is the 
> equilateral triangle.

Most practical?  It requires separate control line for .2db additional 
in any one direction, but narrows the beamwidth [with reference to 
1/2-power points] to do this, making signals +/- 60 degrees much lower 
in intensity than the right-angle system.

Versatile only in respect to that .2 db gain and beam 'pointing'.

> When only two elements at a time are used (the third being 
> disconnected), an equilateral triangle gives three directions along the 
> sides. With three identical elements and ground-planes, you have easy 
> reversal for a total of six directions.

Easy reversal - with a separate control line and more phasing lines.

> When all three elements are used, usually one is driven with 100% 
> current, and the other two are driven at the same phase with about 50% 
> current each. The beam directions are off the top or the bottom of the 
> triangle (so they are moved around 60deg compared with the two-element 
> case). The gain is higher using all three elements, but beam switching 
> is much less simple so you may be practically restricted to only three 
> directions.

Yes ... much less simple.

> Any right-angled triangle would be less versatile than either of these 
> equilateral cases.

Absolutely NOT less versatile.  Look at the beam pattern for a 
two-element array fed 90 degrees out of phase and spaced 1/4 wavelength. 
  Then place FOUR of these patterns around the origin of the plot at 90 
degree rotation.  Notice that all directions are covered with less than 
.5db reduction from the center of the beam pattern.

Being able to do all the switching over the coax with ONE phasing line 
makes for a very simple array.



TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>