You are right it certainly could be a clone tower. This was formerly a
Loran tower and probably purchased for the government on a lowest cost
basis. I would certainly like to think that it a clone and was manufactured
to a lower spec. It looks like a swaged reduction but the reduction is very
sharp. I compared it with some other R25 tower sections and they have a
tapered swag. I cut another leg off the tower section and posted a couple
73 Terry - AB5K
----- Original Message -----
From: "Jim Jarvis" <firstname.lastname@example.org>
To: <email@example.com>; <firstname.lastname@example.org>
Sent: Saturday, April 29, 2006 11:23 AM
Subject: Is that really Rohn?
> I looked at the .jpg at the link:
> It appears that the 'inner' section is a tube
> welded inside the outer, not a swaged reduction, like Rohn.
> Additionally, I've never seen Rohn 25 with a welded-
> on slug on the outside...visible just under the
> rust-through section.
> Is it possible this was a knock off, rather than
> actual Rohn? Or, is my experience with Rohn 25 more
> limited than I thought?
> Based on the pic, it appears to me that the rust developed
> where the tower wasn't galvanized...on the inner tube, inside,
> above the weld, and on the lower surface of the aforementioned slug.
> It suggests that the structure was not hot-dip galvanized after welding,
> which was a Rohn spec.
TowerTalk mailing list