[Top] [All Lists]

[TowerTalk] ProSisTel question

To: <>
Subject: [TowerTalk] ProSisTel question
From: "Stone, Gary R." <>
Date: Thu, 18 May 2006 10:19:47 -0500
List-post: <>
Greetings TT hams,


My advisor is on his way to Dayton so I thought I would ask the Tower Talk pros 
to field this questions.  I have the ProSisTel 61D rotator and hope to install 
it on Saturday.


Two questions come to mind.  First, the back plate on the motor has only two 
screws holding it in place. It does have a rubber gasket.  You have to take it 
off to connect the control cable wire and then put the plate back in place.  
With only two screws I am thinking about putting some kind of sealer around the 
plate?  How about 'liquid tape' or silicon?  Any ideas appreciated.


Second, does someone have the M2 2800DC rotator laying around and can give me 
the height from the bottom of the rotator to the round plate on top (NOT 
including the mast clamps).  I believe it is very close to the ProSisTel 61D (8 
½ inches) but I am not certain?  I just don't want any surprises if possible on 
Saturday when replacing the 2800DC with the ProSisTel.


Thanks and have a good day.


Gary, N5PHT



TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] ProSisTel question, Stone, Gary R. <=