Towertalk
[Top] [All Lists]

## Re: [TowerTalk] Calculating dead weight stress on mast when toweris cran

 To: towertalk@contesting.com Re: [TowerTalk] Calculating dead weight stress on mast when toweris cranked over K4SAV Wed, 31 May 2006 18:21:25 -0500
 ```....I am also concerned about wind loading with the tower vertical and the mast's ability to handle that. ".... The software obtained from the link below, shows that the ratings of your mast will be exceeded at 62.6 mph average with gusts to 80.4 mph. Free software: Download the file labled TRANVITY.ZIP at http://www.arrl.org/qexfiles/ Also download the following pdf file which is a good explanations of the calculations. http://www.arrl.org/qex/1123.pdf Jerry, K4SAV k4zrj@bellsouth.net wrote: >To all the antenna & mast engineers out there, > >I have a 55' crankup / tiltover tower that uses a 24' aluminum mast 6061-T6511 >2" OD .25" wall. >My question is this: does anyone have a formula for calculating the dead >weight load on the mast when the tower is horizontal? The mast extends 18' >above the top of the tower (6' in the tower with two thrust bearings and >rotor). At 3' above the top of the tower is mounted a HyGain TH7DX (75 lbs >dead weight, 9.5 square feet wind load). Ten feet above that is a homebrew >beam for 30, 17 and 12 meters that weighs 50 lbs and has a windload of approx >5 square feet. With the tower approaching horizontal, and the antennas just >off the ground, the mast bends at an angle that really makes me think it is >about to permanently deform, but so far it hasn't. I want a way to figure what >margin of safety I have, if any, in lowering the antennas to make >adjustments/changes. I probably need to change to a stiffer mast, but when I >started this tower project, I didn't plan on adding the top antenna. The mast >should be rated at 40,000 psi yield strength, but how does that relate to >resistance to d > eformation with a 50 lb load at 13' away from the tower along with a 75 lb > load (TH7DX) at 3' from the tower? > >I am also concerned about wind loading with the tower vertical and the mast's >ability to handle that. For the time being, I keep the tower nested when I'm >not chasing DX, so it isn't exposed to high wind gusts. > >Any and all replies are appreciated. I searched the archives, but didn't see >anything that fits this situation. > >Thanks & 73, >Charles, K4ZRJ > >_______________________________________________ > > > >_______________________________________________ >TowerTalk mailing list >TowerTalk@contesting.com >http://lists.contesting.com/mailman/listinfo/towertalk > > > _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk ```
 Current Thread [TowerTalk] Calculating dead weight stress on mast when tower iscranked over, k4zrj Re: [TowerTalk] Calculating dead weight stress on mast when toweriscranked over, Bill [TowerTalk] Phillystran for Wire Dipoles in Trees?, Jim Brown Re: [TowerTalk] Phillystran for Wire Dipoles in Trees?, Kevin Stover Re: [TowerTalk] Phillystran for Wire Dipoles in Trees?, Keith Dutson Re: [TowerTalk] Phillystran for Wire Dipoles in Trees?, Mike Rhodes Re: [TowerTalk] Calculating dead weight stress on mast when toweris cranked over, K4SAV <=