DITTO...if one can't figure it out one ought not to purchase the device.
The manufactures are not going to hold the bag for folks that screw-up, get
a finger smashed or cut-off, or worse because they are messing around with
dangerous gear. Probably the reason there are no instructions available.
Having said that...I replaced the cables on a 100ft Tri-EX crank-up. Not a
big deal just time consuming. The vendor sold me a couple of short cables
which we didn't find out about till crank-up time - that was fun, haha. He
replaced them free of charge so we have some "new" extra cables for other
uses ;-)
Good Luck
73,
dave
wa3gin
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of HFDXJUNKIE@aol.com
Sent: Tuesday, June 06, 2006 9:12 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Tower restring
I am not sure why everyone needs these so call diagrams to replace cable,
take off the old ones..measure replace. Not too hard of a job, esp if the
tower
is on the ground !!!!! Doing it while the tower is standing is a little
trickier. If you do not have the mechanical skill to do it, better call in a
pro
and spend the 2 bucks. I often wonder how many people get seriously hurt and
killed everyday from being CHEAP on any project not just towers. Yeah I know
all about it, spend a few grand on towers and antennas now you have no
money
to pay a pro for some help you can't really handle..oh well, so life goes.
Pete NA2P
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|