W3LPL covered the coax question. But, here is a suggestion about the
switch: put it at the base of the tower!
We learned that lesson the hard way during WPX CW this year in the KD4D @
N3HBX M/2 effort. There is one feedline running to each of the four 200'
rotating towers, with a switch on each tower.
One of the switches fried and we could not select any antenna on the tower
that has the 2el 80m yagi and the 7/7/7 15m stack. The switch was at the
140' level. Had it been closer to the ground, we would have been easily
able to replace it with a backup (if available) or at least bypass it with a
barrel connector to select an antenna.
A switch near ground level is not only quicker to fix, but doing so is not
dependant on daylight or nice weather. You'll appreciate it when Murphy
makes his contest-weekend visits!
----- Original Message -----
From: "Keith Dutson" <email@example.com>
To: "TowerTalk" <firstname.lastname@example.org>
Sent: Monday, August 07, 2006 5:41 PM
Subject: [TowerTalk] Coax Run To Tower
>I have to make a rather long run from the shack to tower, about 500 feet.
> This tower will have 2 el 80 + 8/8/8 stack 10 + log periodic covering
> What kind of coax would you run assuming only one line is needed, switched
> between the three arrays?
> 73, Keith NM5G
TowerTalk mailing list