This brings to mind several questions.
>I had a Ham IV rotor serviced by Norms and had them install a quick
> disconnect connector in place of the terminal strip.
How did they install this. The rotator depends on this area not being
sealed so it can breathe.
> The short cable from the rotor to the male connector they installed
> has a black sealant around where the cable exits the connector.
> I have installed the female connector to my rotor cable and want to
> seal the space where the cable exits the connector. What type of
> sealant is best to use here? The connector is an Amps 9-pin of which
> 8 are used. The female end is labelled 206708-1.
> What have you found to be the best way to waterproof the mated
> connectors on the tower?
It depends on whether you want really good, or something that can be easily
I use the "liquid Electrical tape" liberally.
In this case I'd fill the rear of the connector (the screw off cap) with
electrical putty, *stuff*, or "coax seal" to elminate all voids. (Enough
that it squeezes out the back when the cap is screwed on.) Then at least
three layers of the liquid electrical tape. Some prefer to wrap the
connectors with a good conforming tape first. I don't as I figure I can get
a better seal with the liquid tape going on first, but with care the tape
can do a good job as well. The connector has to be really clean for the
liquid to work well. In the case of the connector having some oil of
silicone on it the tape would be a better approach as it doesn't need 100%
adhesion as long as it gets a couple layers giving 100% coverage. I'd still
go over the tape with a couple layers of the liquid tape though extending
the coverage out beyond the area covered by the tape.
Roger Halstead (K8RI and ARRL 40 year Life Member)
N833R - World's oldest Debonair CD-2
www.rogerhalstead.com (Use return address from home page)
> TowerTalk mailing list
TowerTalk mailing list