[Top] [All Lists]

Re: [TowerTalk] Rotor connector waterproofing?

To: "TowerTalk" <>
Subject: Re: [TowerTalk] Rotor connector waterproofing?
From: "Keith Dutson" <>
Date: Thu, 10 Aug 2006 16:46:49 -0500
List-post: <>
This reminded me of another option.  Lately I have been using one layer of
88 and another layer of rubber fusion tape.  This is the tape used to seal
the fiberglass joints on a SteppIR Yagi.  I purchased my tape off the
Internet.  So far it has been holding up quite nicely.

73, Keith NM5G

-----Original Message-----
[] On Behalf Of JC Smith
Sent: Thursday, August 10, 2006 3:18 PM
Subject: Re: [TowerTalk] Rotor connector waterproofing?

You could use Scotch 88 then Scotchcote then another layer of 88.  I did
that to "repair" (more like "replace"... they were really shot) the plastic
trap caps on an old HyGain tribander and it's still good after 10+ years.
However, for removable connection covers I would prefer 88 followed by
Scotch 23 (rubber splicing tape) and then another 88.

73 - JC, K0HPS


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>