Where did you get the fusion tape (like on the SteppIR). When I put my
SteppIR together I was really impressed with the fusion tape, but can't find
a good supplier that sells it in a reasonable length, i.e., longer than 6ft
(Radio Shack) or less than huge amounts required as a minimum order by many
73, Bob - W3YY
----- Original Message -----
From: "Keith Dutson" <email@example.com>
To: "TowerTalk" <firstname.lastname@example.org>
Sent: Thursday, August 10, 2006 9:46 PM
Subject: Re: [TowerTalk] Rotor connector waterproofing?
> This reminded me of another option. Lately I have been using one layer of
> 88 and another layer of rubber fusion tape. This is the tape used to seal
> the fiberglass joints on a SteppIR Yagi. I purchased my tape off the
> Internet. So far it has been holding up quite nicely.
> 73, Keith NM5G
> -----Original Message-----
> From: email@example.com
> [mailto:firstname.lastname@example.org] On Behalf Of JC Smith
> Sent: Thursday, August 10, 2006 3:18 PM
> To: K7LXC@aol.com; email@example.com; WW5L@gte.net
> Subject: Re: [TowerTalk] Rotor connector waterproofing?
> You could use Scotch 88 then Scotchcote then another layer of 88. I did
> that to "repair" (more like "replace"... they were really shot) the
> trap caps on an old HyGain tribander and it's still good after 10+ years.
> However, for removable connection covers I would prefer 88 followed by
> Scotch 23 (rubber splicing tape) and then another 88.
> 73 - JC, K0HPS
> TowerTalk mailing list
TowerTalk mailing list