I have several of the APC units too. The only time they've cycled/failed
for me is when the batteries were about done in and wouldn't hold a charge..
After replacing the batteries, they behaved. I get 3 to 5 years out of a
battery. Depends if it's been completely discharged a few times or not.
----- Original Message -----
From: "Doug Rehman" <firstname.lastname@example.org>
Sent: Thursday, August 24, 2006 9:55 PM
Subject: [TowerTalk] OT: Generators and UPS's
>I realize this is off topic, but I can't find an answer elsewhere and
> TowerTalk has the best technical resources I can think of. (OK, I guess I
> can tie it to towers, because the generator will run the tower winch in
> event of a power failure and the computer in the shack has a UPS and will
> eventually control the rotator...)
> I have a generator with an automatic transfer switch. In the event of grid
> failure, I have more than enough capacity to run the house, shack, and
> office (all co-located). I have numerous computers in my office; each has
> line conditioner (primarily useful for over/under voltage events) and a
> plugged into the line conditioner.
> Yesterday, the grid went down for about an hour. The generator came on
> about 30 seconds; the UPS's carried the computers during this interval.
> of the UPS's began to switch on and off. The generator was running at
> 40% average load; the voltage fluctuation couldn't have been very much, as
> the line conditioners were not reacting at all. While I didn't monitor the
> frequency, in the past I haven't seen it change much.
> I always set the UPS's for maximum tolerance of noise and voltage. The UPS
> on my primary computer was one of the ones cycling on and off. It was
> reporting noise as the reason. That UPS, along with all of the others that
> were cycling, died after around 15 minutes.
> Interestingly, the three UPS's that weren't cycling were Belden
> models that I would consider cheaper units. The more expensive APC units
> some cheaper Conext units all cycled and failed.
> The generator is well grounded and connected to the single point ground
> 2" copper strap.
> It is pretty certain that the cycling culprit is noise and I doubt I could
> clean the line sufficiently to make the sensitive UPS's behave- especially
> since the line conditioners have noise filters in them already. (There are
> lot of posts similar to this in the Usenet, but I couldn't find any
> I need to replace about 7 or 8 UPS's, from 500VA to 1500VA. Has anyone
> down this road before and found a reliable UPS model and/or brand for use
> with a generator?
> TowerTalk mailing list
TowerTalk mailing list