When I arrived in the Miami area in 1967, the Agonic (0 degrees
variation/declination) line passed right over us. Now, we're almost 6
The only thing that doesn't change is... ....Change.
----- Original Message -----
From: "Jim Lux" <email@example.com>
Sent: Sunday, August 27, 2006 11:58 AM
Subject: Re: [TowerTalk] How is the best way to bend rebar
> At 05:21 PM 8/26/2006, Cqtestk4xs@aol.com wrote:
>>In a message dated 8/26/2006 11:45:58 P.M. Greenwich Standard Time,
>>I'm having a bunch of concrete work done for landscaping, and after
>>watching the guys bending and cutting rebar to go around curves and such,
>>I'm never bending rebar by hand or cutting it with a hacksaw again.
>>Cutting rebar is a piece of cake using a 7 inch grinding blade in a
>>saw. It takes about 15 seconds to reach about 2/3 through and then just
>>snap it at the cut. I've done dozens of these and it's a sure fire way
>>for the average guy working with rebar.
> The nifty bender/cutter does it in literally a second. It's like a
> specialized bolt cutter with a lot of leverage. And, doesn't require AC
> power, or picking up another tool (or, as happened on a job I was doing a
> few years back, dropping the angle grinder in the mud)...
> However, if you're doing the bending by hand (or with a conduit
> bender/piece of pipe), the abrasive cutter is pretty fast.
> I guess the overall point is that nobody needs to struggle with rebar
> unless they really want to. There's lots of ways to bend and cut it. (Now
> that I'm not in my foolish 20s and have an income to pay for it, I
> particularly like the option of "let someone else do it")
> TowerTalk mailing list
TowerTalk mailing list