[Top] [All Lists]

[TowerTalk] Chucking the ground rod

Subject: [TowerTalk] Chucking the ground rod
From: Nick Pair <>
Date: Wed, 30 Aug 2006 21:12:49 -0700 (PDT)
List-post: <>
Placing a 5/8 ground rod in a 5/8 chuck will work till you hit a hard rock of 
dense clay and then the mushrooming will get ya. That's a been there done that 
  I have also seen on some hammer drill models that in the hammer mode that the 
shape of the rod compared to the bits made for the hammer does not allow the 
rod to contact the hammer piston follower and enable the hammer only mode. The 
follower has to be pushed up about 3/16 inch to contact the hammer through the 
cushion between them. That's why the rod adapters are mandatory on some models.
  The clay up here in the north west is only about a 100 years short of being 
rock. It chips just like it and is impermeable to water. A 16 lb sledge just 
mushrooms the rod after a foot or so but the larger hammers will do the job 
albeit slowly though.
  I would complain to where you rented it as they instructed you as to its 
usability and it was unsuitable. A rent reduction at least, or another 4 hours 
on them with one that works.
  Good luck,
  Skookum clay country

Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls.  Great rates 
starting at 1¢/min.

TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>