I have a run of direct-burial coax simply buried a couple of inches in the
ground, along with my radial system. I used to have a control cable lying
on top of the ground, until it got sucked into a lawnmower. I have a long
roll of flexible black plastic (water pipe or conduit?) that I pulled out of
a dumpster, on hand to serve as conduit if I ever decide to re-install the
For the A.C. from house to shack, a friend from the power company gave me a
hunk of direct-burial aluminium pigtail wire (the stuff that carries the
220v w/neutral from the pole transformer to the house). But I put it inside
PVC conduit before burying it, to protect it from accidental damage in case
someone hit it while digging. I rented a trencher and buried it about 3 ft.
in the ground, so I don't anticipate anyone digging that deep on my property
for any reason, without my supervision.
We used to have an electric stove in the kitchen, but later changed over to
propane, so I had a spare 40A circuit. I attached the line going to the
shack to that breaker, since 220V@40 amps is sufficient for anything I use
out there, including KW transmitters. I have an additional breaker box in
the shack with several 20 and 30 amp circuits running inside the building. I
just made sure I linked the pigtail cable to the rest of the system using
the proper copper/aluminium connectors where needed, including the grey
putty stuff you are supposed to use on those connectors, and after 15 years,
have never had any trouble with that run, and with the cable, rated for 100
or 200 amps, the voltage regulation in the shack is excellent.
I shouldn't think it would make any difference what cables you mixed
together inside underground plastic conduit, as long each cable has the
proper insulation rating for the voltage it carries. In any case, the
cables should be waterproof, since even a perfectly impermiable conduit pipe
could fill up with water over the years from condensation, unless you keep
it under pressure with dry nitrogen like the heliax broadcast stations use
to feed the tower. My main concern is hum induced by ground loops, not
insulation breakdown of the cables.
I also have a telephone line going out to the shack, but it runs overhead,
using standard telephone company drop cable (another dumpster find).
I have 120 quarter-wave radials round my tower, which serves as a quarter
wave vertical on 160 (16,000 ft. of copper wire total). The only lightning
damage I have ever experienced with anything associated with the
tower/antenna system is some shattered guy wire insulators as well as a
smoked thermocouple rf ammeter that was apparently destroyed by induction
from a nearby strike even though the feedline was completely disconnected
from the system at the time.
This message was typed using the DVORAK keyboard layout.
TowerTalk mailing list