This reflector - Only antennas that go on towers?
I've been thinking about putting up a 160 loaded vertical of 12 gauge wire
but did not intend to "buy" the coil. And my 60 ft tree just died and I had
to cut it down. Now I'm at about 40-45 feet, maybe. Would someone do the
calcs for a coil of 12 gauge copper wire at the feedpoint to make a 160
antenna of a 45 ft vertical? Just a starting point is fine. Capable of
full legal limit. Sorry, phone band (for now).
Any mods to the request welcome with buildable examples.
Use chain link fence top rail 2x21=42 ft.(probably galvanized steel) for the
vertical instead of 12 ga copper?
Bite the bullet and buy copper or aluminum pipe for the vertical? How big?
Coil at the midpoint?
Top hat (reasonable)?
Copper or aluminum tubing instead of wire for coil?
Would a center loaded 1" aluminum vertical of 45 ft with a top hat (5 or 6
ft or less in diameter) work? Rope over the tree to hold it in place.
I just want something relatively inexpensive I can build.
Thanks, de Jim KG0KP
TowerTalk mailing list